When and how should I clean or replace the air filter?
-
See below.
Cleaning the Air Filter and Vents
Clean the projector's air filter or vents if they get dusty.- Turn off the projector and unplug the power cord.
- Gently remove the dust from the air intake vent using a small vacuum designed for computers or a very soft brush (such as a paintbrush).
Note: Do not vacuum the air filter, or you may damage it. Do not rinse the air filter in water or use any detergent or solvent to clean it.
Caution:
Do not use canned air. The gases may leave a flammable residue or push dust and debris into the projector's optics or other sensitive areas. If the streaming media player is not installed, disconnect the HDMI and power supply USB cables from the projector during cleaning. Otherwise, the ports of the cables may get dusty, resulting in a malfunction.Caution:
If the streaming media player is not installed, disconnect the HDMI and power supply USB cables from the projector during cleaning. Otherwise, the ports of the cables may get dusty, resulting in a malfunction. - If dust is difficult to remove or the air filter is damaged, replace the air filter.
Replacing the Air Filter
You need to replace the air filter in the following situations:- The air filter is torn or damaged
- Dust on the filter is difficult to remove
You can replace the air filter while the projector is mounted to the ceiling or placed on a table.
- Turn off the projector and unplug the power cord.
- Remove the rear cover and air filter cover.
- Pull the air filter out of the projector.
Note: Air filters contain ABS resin and polyurethane foam. Dispose of used air filters according to local regulations.
- Place the new air filter in the projector as shown and push gently until it clicks into place.
- Replace the rear cover and air filter cover.
Optional Equipment and Replacement Parts