text.skipToContent text.skipToNavigation

How do I connect my WPS-enabled wireless router to my product?

    See below.

    Using WPS to Connect to a Network

    If you have a WPS-enabled router or access point, you can use Wi-Fi Protected Setup (WPS) to connect your device to the network.

    Note: To check if your router is WPS-enabled, look for a button labeled WPS on your router or access point. If there is no hardware button, there may be a virtual WPS button in the software for the device. Check your network product documentation for details.

    1. Press the WPS button on your router or access point.
    2. Hold down the Wi-Fi button on your product for about five seconds until the  Wi-Fi light and  Wi-Fi Direct light flash alternately. The  Wi-Fi light turns green to indicate a successful connection.

      Note: Be sure to press and hold the Wi-Fi button on your product within 2 minutes of pressing the WPS button on your router or access point.

Published:  May 2, 2019 Was this helpful​? Thank you for the feedback!
Please tell us why this was not helpful.​
Please enter a valid email address