text.skipToContent text.skipToNavigation
Home Support Projectors Pro Series Epson Pro L20000U

How do I connect my image source to the product?

    See below.

    Connecting to Video Sources

    Follow the instructions in these sections to connect video devices to the projector.

    Related tasks

    Connecting to an HDMI Video Source
    Connecting to a Component-to-BNC Video Source
    Connecting to a Component Video Source
    Connecting to an SDI Video Source

    Connecting to Computer Sources

    Follow the instructions in these sections to connect a computer to the projector.

    Related tasks
    Connecting to a Computer for VGA Video
    Connecting to a Computer for HDMI Video
    Connecting to a Computer for DVI-D Video
    Connecting to a Computer for 5 BNC Video
    Connecting to a Computer for DisplayPort Video

    Connecting to an HDBaseT Transmitter

    To send an HDMI or RS-232C signal over a long distance, you can connect the projector to an optional HDBaseT transmitter using a 100Base-TX network cable. This is useful when you want to send a signal to or control the projector from a remote location, such as in a hall or event site, since you can use a network cable up to 328 feet (100 m) in length. To ensure proper data transmission, use a Category 6 STP cable or better.
    1. Turn off the projector and HDBaseT transmitter.

      Note: Make sure the projector and HDBaseT transmitter are turned off when connecting or disconnecting a network cable between the two devices.

    2. Connect one end of the network cable to the HDBaseT port on the transmitter.
    3. Connect the other end to the projector's HDBaseT port.

      Note: See the documentation that came with the HDBaseT transmitter for instructions on connecting it to your video device or computer.

    4. Turn on the projector and HDBaseT transmitter.

    Note: To enable communication from the Ethernet and serial ports on the transmitter, select On as the Control Communications setting in the projector's Extended menu. Turning on this setting disables the projector's LAN, RS-232C, and Remote ports. If you connected an Extron XTP transmitter or switcher to the projector's HDBaseT port, select On as the Extron XTP setting in the projector's Extended menu.

    Related references
    Projector Setup Settings - Extended Menu
Published:  Nov 21, 2019 Was this helpful​? Thank you for the feedback!
Please tell us why this was not helpful.​
Please enter a valid email address