text.skipToContent text.skipToNavigation
Home Support Scanners WorkForce Series Epson WorkForce DS-575W

How do I connect my WPS-enabled wireless router to my product?

    See below.

    Using WPS to Connect to a Network

    If you have a WPS-enabled wireless router or access point, you can use Wi-Fi Protected Setup (WPS) to connect your scanner to the network.
    1. Open the input tray.
    2. Press and hold the WPS button on your wireless router or access point until the security light flashes.

      Note: If you cannot locate the WPS button, or there are no buttons on the router or access point, see the documentation provided with your router or access point for details.

    3. Press and hold the  Wi-Fi connect button on the scanner for at least 3 seconds, then release it when the  Wi-Fi light flashes blue. The  Wi-Fi and  AP mode lights flash alternately while establishing the connection. When the  Wi-Fi light on the scanner stays on, the scanner is connected to the network.

      Note: If the ! error light turns on, the connection failed. Press the  stop button to clear the error, restart the router or access point, and repeat these steps.

    Related tasks
    Setting Up Network Scanning
Published:  Jul 13, 2017 Was this helpful​? Thank you for the feedback!
Please tell us why this was not helpful.​
Please enter a valid email address