text.skipToContent text.skipToNavigation

My product doesn't detect my photos placed on the scan bed when I use the reprint/restore function on the control panel. What should I do?

    Check the following:

    • Make sure the scan bed glass is clean and free of finger prints, smudges, etc. (When cleaning the glass, spray the glass cleaner onto a cloth and then wipe the glass. Never spray glass cleaner directly onto the scan bed.)
    • Make sure the photos are placed on the scan bed correctly. See Place Originals for Copying or Scanning.
    • Make sure the photos are no larger than 5 x 7 inches for one photo or 4 x 6 inches for two photos.
    • When copying two photos (up to 4 x 6 inches), place them 1/4 inch (5 mm) apart as shown below.
Published:  Aug 30, 2010 Was this helpful​? Thank you for the feedback!
Please tell us why this was not helpful.​
Please enter a valid email address