I see the message Service Request 00010004 - 000101D. What should I do?

• Service Request errors in the range 00010004 - 000101D are related to a carriage movement problem. In some instances like paper jams, the carriage locking tab may be partially pushed in, causing the carriage locking mechanism to put a drag on the carriage or lock the carriage completely. This will cause a carriage error. Make sure the carriage locking tab is pulled to the left. Then turn the printer's power off and release the carriage by pushing down on the cutter blade. Slide the carriage to the left and look for any paper that also may be restricting the carriage from moving freely.
  
  

  00010004	CR Motor encoder check error
  00010005	CR Motor out of step
  00010006	CR Motor over current
  00010007	CR Motor in-position time-out
  0001000A	CR axis detection error
  0001000F	CR Motor PWM output faulty
  0001001D	CR servo parameter error

  
  The T-Fence may also be dirty or out of the carriage encoder. Check to make sure it is clean and in the center of the encoder. Contact Epson for additional assistance.
  
  The current firmware corrects erroneous Service Request 00010007, which occurs after the power is first turned on. You can download this firmware upgrade from www.prographics.epson.com.