text.skipToContent text.skipToNavigation
Home Support Wearables ProSense Epson ProSense 57

Can the product measure indoor activity?

    Yes. When you set the product to Treadmill mode, it measures your indoor activity as you walk or run on a treadmill. To set your product to Treadmill mode, press down on the Time screen until you see Treadmill and press Start/Stop. Then press Start/Stop again to start workout measurement.

    Note: GPS positioning is disabled when you set the product to Treadmill mode. The product uses the built-in stride sensor instead to record measurements, but the product does not record some measurements that require GPS signals, such as your workout route.

    To ensure that your measurements are as accurate as possible, do one of the following before you use the product indoors:

    • If there are no obstacles overhead that could block GPS signals, run or walk outside for approximately 10 minutes while the product is on and GPS positioning is active.
    • If there are obstacles overhead, such as tall buildings or trees, run or walk outside for approximately 30 minutes while the product is on and GPS positioning is active.
Published:  Aug 30, 2017 Was this helpful​? Thank you for the feedback!
Please tell us why this was not helpful.​
Please enter a valid email address