What settings do the DIP switches control?

• The LQ-1500 does not have DIP switches at the main case of the
  printer. The switches are located in the interface module.
  
  The parallel module has two 8-position DIP switches. These switches
  are located at the rear of the printer.
  

  Switch	ON	OFF
  SW 1-1	2K Input Buffer	1 Line Buffer
  SW 1-2	Paper Out Inactive	Paper Out Active
  SW 1-3	CR Produces CR + LF	CR Only
  SW 1-4	Not Used-Always OFF	Not Used-Always OFF

  
  

  Country	SW 2-1	SW 2-2	SW 2-3
  USA	ON	ON	ON
  France	ON	ON	OFF
  Germany	ON	OFF	ON
  United Kingdom	ON	OFF	OFF
  Denmark	OFF	ON	ON
  Sweden	OFF	ON	OFF
  Italy	OFF	OFF	ON
  Spain	OFF	OFF	OFF

  
  

  Switch	ON	OFF
  SW 2-4	12" Page Length	11" Page Length
  SW 2-5	1" Skip over Perf	Skip over Perf Inactive
  SW 2-6	Sound Bell	Bell Silent
  SW 2-7	Letter Quality	Draft
  SW 2-8	SLCT IN Active	SLCT IN Inactive

  Cut Sheet Feeder Mode
  
  The Cut Sheet feeder mode is enabled by turning on Switch 8 on
  the bank of switches inside the printer. This DIP switch is
  under the front cover (front right corr>2,3. If both DSR and DCD signals are not ON state (Positive), RXD signal can not be received.
  
  4,5. If the host computer is not equipped with the power supply for the Current Loop interface, these jumpers must be connected to perform communication via the Current Loop interface.
  
  6. J10 and J11 jumpers can not be connected at the same time.
  
  7. JX and JF jumpers can not be connected at the same time.
  
  8. JRS and JCL jumpers can not be connected at the same time.
  
  9. "ON" denotes the connection of the jumper while "OFF" denotes the disconnection of the jumper.