Home Support Printers Single Function Inkjet Printers Epson Stylus Series Epson Stylus Pro 7900 Computer To Plate System

Can I adjust my product for feed length and do I need to do this?

  • Yes, The EFI RIP has an adjustment to compensate for feed length of the Printer because each printer may feed slightly differently. It is HIGHLY recommended that you adjust for this when you first install the printer and the RIP and it should not need to be adjusted again. The adjustment is specified in the "Preferences" window under the "printer" tab and "media Size" sub-tab as shown below:


    The correct process is to enter the target value (430 mm above) and the actual length (430 mm to start). Then, print an alignment sheet that has the included 430 mm line. Measure the line after the printing is complete and then enter the ACTUAL number you measure to the 0.xx mm. Here is the 430 mm line on the alignment sheet (outlined in red):
Published:  Sep 30, 2011 Was this helpful?​ Thank you for the feedback!
Was this helpful?​
Please tell us why this was not helpful.​
Please enter a valid email address