Home Support Projectors PowerLite Series Epson PowerLite Home Cinema 3900

How do I charge the Epson RF 3D active shutter glasses?

  • See below.

    Charging the 3D Glasses

    When the status light on the glasses flashes red to indicate a low battery, it is time to charge the glasses.
    1. Connect the smaller end of the charging cable to the port on the bridge of the glasses.

      Note: Make sure you connect the cable in the correct orientation or you may damage the glasses or cable.

    2. Do one of the following:
      • Plug the other end of the charging cable into a powered USB port on a computer or other device.
      • Plug the other end of the charging cable into a USB-to-AC adapter with the following specifications:

        Input: 100-240V, ~0.15A, 50-60Hz

        Output: 5V=1A

    The glasses are fully charged when the status light on the glasses stays green.
Published:  Sep 12, 2016 Was this helpful?​ Thank you for the feedback!
Was this helpful?​
Please tell us why this was not helpful.​
Please enter a valid email address