How do I connect my WPS-enabled wireless router to my product?
Using WPS to Connect to a NetworkIf you have a WPS-enabled wireless router or access point, you can use Wi-Fi Protected Setup (WPS) to connect your scanner to the network.
- Open the input tray.
- Press and hold the WPS button on your wireless router or access point until the security light flashes.
Note: If you cannot locate the WPS button, or there are no buttons on the router or access point, see the documentation provided with your router or access point for details.
- Press and hold the Wi-Fi connect button on the scanner for at least 3 seconds, then release it when the Wi-Fi light flashes blue. The Wi-Fi and AP mode lights flash alternately while establishing the connection. When the Wi-Fi light on the scanner stays on, the scanner is connected to the network.
Note: If the ! error light turns on, the connection failed. Press the stop button to clear the error, restart the router or access point, and repeat these steps.
Setting Up Network Scanning