Home Support Scanners DS Series Epson WorkForce DS-560

How do I set up my product with a WPS-enabled router or access point?

  • If you have a WPS-enabled wireless router or access point, you can use Wi-Fi Protected Setup (WPS) to connect your scanner to the network.
    1. Set the connection mode switch on the scanner to Wi-Fi.
    2. Open the input tray and turn on the scanner.
    3. Press and hold the Connect button on the scanner for at least 3 seconds, then release it when the Status and ! error lights flash alternately.

      The scanner enters standby mode for WPS connection for two minutes.
    4. Press the WPS button on your router or access point. The Status light on the scanner stays on, indicating that the scanner is connected to the network.
    5. Set up network scanning on your computer.
    Related tasks
    Setting Up Network Scanning
Published:  Feb 11, 2015 Was this helpful?​ Thank you for the feedback!
Was this helpful?​
Please tell us why this was not helpful.​
Please enter a valid email address