Support Scanners WorkForce Series Epson WorkForce ES-65WR

I cannot scan over a network. What should I do?

  • If you cannot scan over a network (ES-60W/ES-65WR) with Epson ScanSmart or start the Epson Scan 2 Utility, try these solutions:

    • Make sure the  Wi-Fi switch is set to the  Wi-Fi position.
    • Make sure the computer and scanner are connected to the same network (or network segment/VLAN).
    • Move the scanner and computer or smart device closer to the router or access point.
    • If you cannot scan using the  start button on the scanner, make sure you restarted your computer after installing the scanning software.
    • If you are scanning a large original at a high resolution, a network communication error may occur. Try scanning again at a lower resolution.
    • Check the network connection setting in the Epson Scan 2 Utility.
    • You may need to disable the firewall and any anti-virus software on your wireless router or access point.
    • If you see the message "Network product is not available: currently being used by user", there may be a communication error between the scanner and computer. Restart the scanner.
    • If the Firewall function is active, the scanner may not be discovered by the Epson Scan 2 Utility. Open the Epson Scan 2 Utility, enter the IP address for your scanner, and click Add.
    • If the scanner and computer cannot communicate and are connected to the same network (or network segment/VLAN), the privacy separator on your router must be disabled. Follow the instructions in your router documentation to disable the privacy separator.
    Related information
    Wi-Fi Networking
Published:  Oct 18, 2018 Was this helpful?​ Thank you for the feedback!
Was this helpful?​
Please tell us why this was not helpful.​