What settings do the DIP switches control?

  • The LQ-510 and AP-4000 have two 8-position DIP switches. These switches are located at the panel of the printer under a small access door.

    CountrySW 1-1SW 1-2SW 1-3
    USAONONON
    FranceONONOFF
    GermanyONOFFON
    United KingdomONOFFOFF
    Denmark 1OFFONON
    SwedenOFFONOFF
    ItalyOFFOFFON
    Spain 1OFFOFFOFF

    FontSW 1-4SW 1-5
    RomanOFFOFF
    San SerifONOFF
    SlotOFFON
    DraftONON

    SwitchONOFF
    SW 1-6CondensedNormal
    SW 1-7Graphic CharactersItalic Characters
    SW 1-8CSF EnabledCSF Disabled
    SW 2-112" Page Length11" Page Length
    SW 2-2Tear Off Mode OnTear Off Mode Off
    SW 2-31" Skip over PerfSkip over perf Inactive
    SW 2-4CR Produces CR + LFCR Only
    SW 2-58K Input Buffer
    User-Defined
    Characters Disabled
    1K Input Buffer
    User-Defined
    Characters Disabled
    SW 2-6Bidirectional GraphicsUnidirectional Graphics

    Character PitchSW 2-7SW 2-8
    10 PitchOFFOFF
    12 PitchONOFF
    15 PitchOFFON
    ProportionalONON

    Note: Unidirectional graphics is the printer default. Placing switch 2-6 in the ON position allows selection of Bidirectional graphics after an ESC U O is sent.
Was this helpful?​ Thank you for the feedback!
Was this helpful?​
Please tell us why this was not helpful.​