What settings do the DIP switches control?
The LQ-1010/AP-4500 has two 8-position DIP switches. These switches are
located at the panel of the printer under a small access door.
Country SW 1-1 SW 1-2 SW 1-3 USA ON ON ON France ON ON OFF Germany ON OFF ON United Kingdom ON OFF OFF Denmark OFF ON ON Sweden OFF ON OFF Italy OFF OFF ON Spain OFF OFF OFF Font SW 1-4 SW 1-5 Roman OFF OFF San Serif ON OFF Slot OFF ON Draft ON ON Switch ON OFF SW 1-6 Condensed Normal SW 1-7 Graphic Characters Italic Characters SW 1-8 CSF Enabled CSF Disabled SW 2-1 12" Page Length 11" Page Length SW 2-2 Tear Off Mode ON Tear Off Mode OFF SW 2-3 1" Skip over erf Skip over Perf Inactive SW 2-4 CR Produces CR + LF CR Only SW 2-5 8K Input Buffer 1K Input Buffer User-Defined User-Defined Characters Disabled Characters Enabled SW 2-6 Bidirectional Graphics Unidirectional Graphics Character Pitch SW 2-7 SW 2-8 10 Pitch OFF OFF 12 Pitch ON OFF 15 Pitch OFF ON Proportional ON ON
Note: Unidirectional graphics is the printer default. Placing switch 2-6 in the ON position allows selection of Bidirectional graphics after an ESC U O is sent.
Was this helpful? Thank you for the feedback!