What settings do the DIP switches control?

• The LQ-1010/AP-4500 has two 8-position DIP switches. These switches are
  located at the panel of the printer under a small access door.
  
  

  Country	SW 1-1	SW 1-2	SW 1-3
  USA	ON	ON	ON
  France	ON	ON	OFF
  Germany	ON	OFF	ON
  United Kingdom	ON	OFF	OFF
  Denmark	OFF	ON	ON
  Sweden	OFF	ON	OFF
  Italy	OFF	OFF	ON
  Spain	OFF	OFF	OFF

  
  

  Font	SW 1-4	SW 1-5
  Roman	OFF	OFF
  San Serif	ON	OFF
  Slot	OFF	ON
  Draft	ON	ON

  
  

  Switch	ON	OFF
  SW 1-6	Condensed	Normal
  SW 1-7	Graphic Characters	Italic Characters
  SW 1-8	CSF Enabled	CSF Disabled
  SW 2-1	12" Page Length	11" Page Length
  SW 2-2	Tear Off Mode ON	Tear Off Mode OFF
  SW 2-3	1" Skip over erf	Skip over Perf Inactive
  SW 2-4	CR Produces CR + LF	CR Only
  SW 2-5	8K Input Buffer	1K Input Buffer
  	User-Defined	User-Defined
  	Characters Disabled	Characters Enabled
  SW 2-6	Bidirectional Graphics	Unidirectional Graphics

  
  

  Character Pitch	SW 2-7	SW 2-8
  10 Pitch	OFF	OFF
  12 Pitch	ON	OFF
  15 Pitch	OFF	ON
  Proportional	ON	ON

  
  Note: Unidirectional graphics is the printer default. Placing switch 2-6 in the ON position allows selection of Bidirectional graphics after an ESC U O is sent.