Why am I getting the message Could not complete communicating configuration data when I send settings to the network adapter?
-
This might happen when using a dial-up router. Run MS-DOS Prompt or Command Prompt from the computer in which EpsonNet WinAssist is installed, then enter the following command: >ROUTE_ADD_[the IP address of the network adapter]_[the IP address of the computer] (each underscore represents one space).
Example: >ROUTE ADD 192.168.192.168 22.33.44.55
Also, reinitialize the network adapter, then try again.
Was this helpful? Thank you for the feedback!
