How do I set up my product with a WPS-enabled router or access point?
If you have a WPS-enabled router or access point, you can use Wi-Fi Protected Setup (WPS) to connect your device to the network.
Note: To check if your router is WPS-enabled, look for a button labeled WPS on your router or access point. If there is no hardware button, there may be a virtual WPS button in the software for the device. Check your network product documentation for details.
- To connect to a WPS-enabled router, press the WPS button on your router or access point.
- Press and hold down the Wi-Fi button on your product for 3 seconds. The left side of the WiFi light turns green to indicate a successful connection.
Note: Be sure to press and hold the Wi-Fi button on your product within 2 minutes of pressing the WPS button on your router or access point.
Control Panel Buttons and Lights
Published: Aug 4, 2015 Was this helpful? Thank you for the feedback!