How should I load envelopes?
-
See below.
Loading Paper and Envelopes in the Rear Paper Feed Slot
You can print envelopes or documents in a variety of paper types and sizes in the rear paper feed slot.- Open the feeder guard and pull up the paper support.
- Slide the edge guides outward.
- If you are inserting a stack of paper, fan the sheets and tap the stack on a flat surface to even the edges.
Note: You can load one sheet of binder paper with holes on one of the long edges as shown. Do not select automatic 2-sided printing for this type of paper.
- Do one of the following:
- Insert paper, glossy or printable side up and short edge first, in the center of the slot.
Caution:
To prevent paper feeding problems, make sure you do not load paper above the arrow marks inside the edge guides. - Load envelopes short edge first, with the flap facing down and the flap edge to the left, in the center of the slot.
- Insert paper, glossy or printable side up and short edge first, in the center of the slot.
- Slide the edge guides against the paper, but not too tightly.
- Extend the output tray.
- Press the Paper Setting button. You see a screen like this:
- Select the size and type of paper you loaded.
- Load only the recommended number of sheets.
- Load paper short edge first, no matter which way your document faces.
- Load the printable side faceup.
- Load letterhead or pre-printed paper top edge first.
- Do not load paper above the arrow mark inside the edge guides.
- If you have trouble loading a stack of envelopes, press each envelope flat before loading it or load one envelope at a time.
- If print quality declines when printing multiple envelopes, try loading one envelope at a time.
- Do not load envelopes that are curled, folded, or too thin.
- Check the paper package for any additional loading instructions.
Loading Paper in the Cassette
Related references
Paper Specifications
Paper Loading Capacity - Open the feeder guard and pull up the paper support.
Published: Jun 22, 2017
Was this helpful? Thank you for the feedback!