What do my product's lights indicate?

• See below.

  Product Light Status

  You can often diagnose problems with your product by checking its lights.

  
  
  

  1	power light
  2	Wi-Fi light
  3	Wi-Fi Direct light
  4	ink light
  5	paper light

  Light status	Condition/solution
  The  power light is on	The product is turned on.
  The  Wi-Fi light is on	The product is connected to a wireless network.
  The  Wi-Fi Direct light is on	The product is connected to a device using Wi-Fi Direct.
  The  power light is flashing	The product is busy. Wait for the  power light to stop flashing before turning off the product.
  The  Wi-Fi and  Wi-Fi Direct lights are flashing	A Wi-Fi connection error has occurred. Press the Wi-Fi button to clear the error and try again.
  The  ink light is on	Initial ink charging or ink refilling may not be complete. See the Start Here sheet for instructions on initial ink charging.
  The  ink light is flashing	The product is low on ink or the maintenance box is nearing the end of its service life. If a message to continue printing appears on your computer, press the  stop button to continue printing.
  The  paper light is on	No paper is loaded or the loaded paper size does not match the print setting. Load the correct size paper in the product and press the  stop button to clear the error.
  The  paper light is flashing	Paper is jammed in the product or protective material remains inside. Remove the jammed paper or any protective material and press the  stop button to clear the error.
  The  ink light is on The  paper light is on	The product was not turned off correctly. Press the  stop button to clear the error, then run a nozzle check and cancel any pending print jobs. Always use the  power button to turn off the product.
  The  ink and  paper lights are flashing simultaneously	The printer cover is open or the output selector is in the incorrect position. Close the printer cover or change the output selector's position.
  The  ink and  paper lights are flashing alternately	The maintenance box is at the end of its service life, not recognized, or installed incorrectly. Replace the maintenance box or make sure it is installed correctly.
  All lights are flashing	Paper or protective material is stuck inside the product. Open the front cover and remove any jammed paper or protective materials. Turn the product off and then back on again. If the error continues, contact Epson for support.
  All lights except the  power light are flashing	An error has occurred during firmware updating. Connect your product using a USB cable and try updating the firmware again. If the error continues, contact Epson for support.

  Related tasks
  Checking for Software Updates
  Related references
  Paper Jam Problems in the Front of the Product
  Paper Jam Problems Inside the Product
  Paper Jam Problems in the Rear Cover
  Where to Get Help
  Related information
  Loading Paper
  Refilling Ink and Replacing the Maintenance Box