How do I connect my WPS-enabled wireless router to my product?

• See below.

  Using WPS to Connect to a Network

  If you have a WPS-enabled wireless router or access point, you can use Wi-Fi Protected Setup (WPS) to connect your product to the network.
  1. Press the  home button, if necessary.
  2. Select Wi-Fi Setup. You see a screen like this:
     
     
  3. Select Wi-Fi (Recommended).
  4. Press the OK button to proceed.
  5. Select Push Button Setup (WPS).
  6. Press the OK button to proceed.
  7. Follow the instructions on the LCD screen to complete WPS setup.
  8. Press the  home button to exit. If the network connection is successful, the icon is displayed on the Wi-Fi Setup LCD screen and should be able to connect to your product directly from your computer or device, and then print. If you are printing from a computer, make sure you installed the network software as described on the Start Here sheet.

     Note: If you don't see the icon, repeat these steps to try again. If you are still not able to connect after repeating these steps, print a network connection report and try the solutions provided.

  Related references
  Status Icon Information