How do I replace the maintenance box?

• Make sure you have a new maintenance box before you begin.

  CAUTION:
  Do not reuse a maintenance box that has been removed and left uninstalled for more than a week. Keep the maintenance box away from direct sunlight.

  Note: You cannot print or clean the printhead while the maintenance box is full, but you can perform tasks that do not require ink, such as scanning.

  1. Make sure the product is not printing.
  2. Remove the new maintenance box from its package.

     CAUTION:
     Do not touch the green chip on the side of the maintenance box. Doing so may prevent normal operation and printing.

     Note: A transparent bag for the used maintenance box is provided with the new maintenance box.

  3. Use a flat-head screwdriver to loosen the screw on the maintenance box cover and remove the maintenance box cover as shown.
     
     
  4. Grasp the maintenance box as shown and pull it out of its holder.
     
     

     Note: Do not tilt the used maintenance box or take it apart.

     Warning: If ink gets on your skin, wash it thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water. If discomfort or vision problems persist, see a doctor immediately. If ink gets into your mouth, spit it out and see a doctor right away. Keep the maintenance box out of the reach of children and do not drink the ink.

  5. Place the used maintenance box in the plastic bag that came with the new maintenance box. Seal the bag and dispose of it carefully.
     
     
  6. Insert the new maintenance box into the holder and push it all the way in. Make sure the box is inserted in the correct direction.
     
     
  7. Insert the maintenance box cover and tighten the screw to secure the cover.
     
     
  8. Check the message on the LCD screen, then press the OK button to confirm. Follow the on-screen instructions.