Support Other Products Connectivity Products Epson C12C800WN (EpsonNet 802.11b Wireless Print Server)

Why am I getting the message Could not complete communicating configuration data when I send settings to the network adapter?

  • This might happen when using a dial-up router. Run Command Prompt from the computer in which EpsonNet WinAssist is installed, then enter the following command; Format: >ROUTE_ADD_the IP address of the network adapter_ the IP address of the computer (the under bar represents one space) Example: >ROUTE ADD 192.168.192.168 22.33.44.55. Also, reinitialize the network adapter, then try again.
Was this helpful?​ Thank you for the feedback!
Was this helpful?​
Please tell us why this was not helpful.​