How do I replace the auto cutter?

• 1. Turn the product off and unplug the product's power cord from the power outlet.
     
     
  2. Open the maintenance box cover.
     
     
  3. Open the front cover.
     
     
  4. With a Phillips screwdriver, loosen the screw shown in step 1 below, then remove the auto cutter cover as shown in step 2.
     
     
  5. Disconnect the cable that connects the auto cutter to the product.
     
     
  6. With a Phillips screwdriver, loosen the two screws shown in step 1 below, then remove the auto cutter from the product.
     
     
  7. Install the replacement auto cutter and secure it with the two screws shown in step 2 below.
     
     
  8. Connect the cable from the auto cutter to the product.
     
     
  9. Attach the auto cutter cover to the product and secure it with the screw shown in step 2 below.
     
     
  10. Close the front cover.
      
      
  11. Close the maintenance box cover.
      
      
  12. Plug the product's power cord into a power outlet, and turn the product on.
      
      
  13. Reset the auto cutter counter. To reset the counter, use the arrow buttons on the product's operation panel to select the following: > Printer Status/Print > Auto Cut Counter > After Replacement.