What settings do the DIP switches control?

  • The LQ-1500 does not have DIP switches at the main case of the
    printer. The switches are located in the interface module.

    The parallel module has two 8-position DIP switches. These switches
    are located at the rear of the printer.
    SW 1-12K Input Buffer1 Line Buffer
    SW 1-2Paper Out InactivePaper Out Active
    SW 1-3CR Produces CR + LFCR Only
    SW 1-4Not Used-Always OFFNot Used-Always OFF

    CountrySW 2-1SW 2-2SW 2-3
    United KingdomONOFFOFF

    SW 2-412" Page Length11" Page Length
    SW 2-51" Skip over PerfSkip over Perf Inactive
    SW 2-6Sound BellBell Silent
    SW 2-7Letter QualityDraft
    SW 2-8SLCT IN ActiveSLCT IN Inactive
    Cut Sheet Feeder Mode

    The Cut Sheet feeder mode is enabled by turning on Switch 8 on
    the bank of switches inside the printer. This DIP switch is
    under the front cover (front right corr>2,3. If both DSR and DCD signals are not ON state (Positive), RXD signal can not be received.

    4,5. If the host computer is not equipped with the power supply for the Current Loop interface, these jumpers must be connected to perform communication via the Current Loop interface.

    6. J10 and J11 jumpers can not be connected at the same time.

    7. JX and JF jumpers can not be connected at the same time.

    8. JRS and JCL jumpers can not be connected at the same time.

    9. "ON" denotes the connection of the jumper while "OFF" denotes the disconnection of the jumper.
Was this helpful?​ Thank you for the feedback!
Was this helpful?​
Please tell us why this was not helpful.​
Please enter a valid email address