I see the message Service Request 00010004 - 000101D. What should I do?
Service Request errors in the range 00010004 - 000101D are related to a carriage movement problem. In some instances like paper jams, the carriage locking tab may be partially pushed in, causing the carriage locking mechanism to put a drag on the carriage or lock the carriage completely. This will cause a carriage error. Make sure the carriage locking tab is pulled to the left. Then turn the printer's power off and release the carriage by pushing down on the cutter blade. Slide the carriage to the left and look for any paper that also may be restricting the carriage from moving freely.
|00010004||CR Motor encoder check error|
|00010005||CR Motor out of step|
|00010006||CR Motor over current|
|00010007||CR Motor in-position time-out|
|0001000A||CR axis detection error|
|0001000F||CR Motor PWM output faulty|
|0001001D||CR servo parameter error|
The T-Fence may also be dirty or out of the carriage encoder. Check to make sure it is clean and in the center of the encoder. Contact Epson for additional assistance.
Published: Dec 12, 2007 Was this helpful? Thank you for the feedback!