How do you replace the projection lamp?
The projection lamp typically lasts for about 1500 hours of use. It is time to replace the lamp when: To maintain projector brightness and image quality, replace the lamp as soon as possible after you see the message. Note: Request replacement lamp part number V13H010L16. Follow these steps to replace the lamp: 1. Turn off the projector, let it cool down, and unplug the power cord. 2. Allow the projector to continue cooling for at least one hour (if it has been on). Warning: Let the lamp cool before replacing it. To avoid premature lamp failure, do not touch the glass portion of the lamp assembly. 3. Turn the projector upside-down to access the lamp compartment. 4. To remove the lamp cover, press on the two tabs and pull out the cover. 5. Use a screwdriver to loosen the two lamp cover screws; you can't remove the screws. Then pull out the lamp by the two notches. 6. Position the new lamp correctly, then gently insert it into the projector. Press it into place and tighten the retaining screws. 7. Insert the lamp cover as shown and press it back into place. Caution: Make sure the lamp cover is securely fastened; the Error light flashes and the projector lamp won't turn on if the cover is open.
Was this helpful? Thank you for the feedback!