Support Projectors Cinema Series Epson PowerLite Pro Cinema 810 HQV

I see the message No Signal. What should I do?

  • Check the following:
    • Press the Source button on the projector or one of the Source buttons on the remote control to select the correct input source. Allow a few seconds for the projector to sync up after pressing the button.
    • Press the Blank button on the remote control to make sure the picture hasn't been turned off temporarily.
    • Check that the power light is green, not flashing, and the lens cover is off.
    • The projector may be in standby (or sleep) mode. If the power light is orange, press the Power button to turn the projector back on.
    • Make sure your video equipment is turned on.
    • Make sure your cable(s) are connected correctly See Connecting the Cables for more information.
Published:  Nov 30, 2006 Was this helpful?​ Thank you for the feedback!
Was this helpful?​
Please tell us why this was not helpful.​