I see the message No Signal. What should I do?

• Check the following:
  • Press the Source button on the projector or one of the Source buttons on the remote control to select the correct input source. Allow a few seconds for the projector to sync up after pressing the button.
  • Press the Blank button on the remote control to make sure the picture hasn't been turned off temporarily.
  • Check that the  Power light is green, not flashing, and the lens cover is off.
  • The projector may be in standby (or sleep) mode. If the  Power light is orange, press the  Power button to turn the projector back on.
  • Make sure your video equipment is turned on.
  • Make sure your cable(s) are connected correctly. See Connecting the Cables.