How do I set a password on my product?

• To use password security, you must set a password.
  1. Turn off the product.
  2. Wait a few moments, then hold down the 1 button on the remote control and press the power button. The commander projector turns on. (The receiver projector stays off.)
  3. After the projector warms up, hold down the Freeze button on the remote control until you see the Password Protect menu. This takes about five seconds.
     
  4. Press the down arrow to select Password and press Enter. You see the prompt "Change the password?".
  5. Select Yes and press Enter.
  6. Hold down the Num button on the remote control and use the numeric buttons to set a four-digit password.
     
     The password displays as **** as you enter it. Then you see the confirmation prompt.
  7. Enter the password again. You see the message "Password accepted."
  8. Press Esc to return to the Password Protect menu.
  9. To prevent unauthorized use of the projector, select Power On Protect, press Enter, select On, press Enter again, and press Esc.
  10. To prevent changes to the User's Logo screen or related display settings, select User's Logo Protect, press Enter, select On, press Enter again, and press Esc.
  11. Press the power button on the remote control. The commander projector turns off.
  12. Wait a few moments, then press the power button on the projector or the remote control. The commander and receiver projectors turn on and your password security is now enabled.
  13. Make a note of the password and keep it in a safe place in case you forget it.

  You can attach the Password Protect sticker to the projector as an additional theft deterrent.

  Note: Be sure to keep the remote control in a safe place; if you lose it, you will not be able to enter the password required to use the projector.