I see the message No Signal. What should I do?

• Try the following solutions:

  • Press one of the source buttons on the remote control, or press the  Source button on the projector, to select the correct input source. Allow a few seconds for the projector to sync up after pressing the button.
  • Press the Blank button on the remote control to make sure the picture hasn't been turned off temporarily.
  • Check that the power light is on and not flashing, and the lens cover is open.
  • The projector may be in standby (or sleep) mode. If the  power button is lit and the power light is off, press the button to turn the projector back on.
  • Make sure your video equipment is turned on.
  • Make sure your cable(s) are connected correctly. See Connecting the Cables.