Home Support Projectors LightScene Series Epson LightScene EV-105

How do I set a password on my product?

  • See below.

    Setting a Password

    To use password security, you must set a password.

    Note: The default password is set to 0000.

    1. Hold down the Effect button on the remote control for about five seconds or until you see this menu.

    2. Press the down arrow to select Password and press Enter (). You see the prompt "Change the password?".
    3. Select Yes and press Enter ().
    4. Press the number buttons to set a four-digit password.

      The password displays as **** as you enter it. Then you see the confirmation prompt.
    5. Enter the password again. You see the message "Password accepted."
    6. Press Esc to return to the menu.
    7. Make a note of the password and keep it in a safe place in case you forget it.
Published:  Jun 21, 2018 Was this helpful​? Thank you for the feedback!
Please tell us why this was not helpful.​
Please enter a valid email address