How do I connect my image source to the product?

• See below.

  Connecting to Video Sources

  Follow the instructions in these sections to connect video devices to the projector.

  Related tasks
  Connecting to an HDMI Video Source
  Connecting to a Component-to-BNC Video Source
  Connecting to a Component Video Source
  Connecting to an SDI Video Source
  

  Connecting to Computer Sources

  Follow the instructions in these sections to connect a computer to the projector.

  Related tasks
  Connecting to a Computer for VGA Video
  Connecting to a Computer for HDMI Video
  Connecting to a Computer for DVI-D Video
  Connecting to a Computer for 5 BNC Video
  

  Connecting to an HDBaseT Transmitter

  To send an HDMI or RS-232C signal over a long distance, you can connect the projector to an optional HDBaseT transmitter using a 100Base-TX network cable. This is useful when you want to send a signal to or control the projector from a remote location, such as in a hall or event site, since you can use a network cable up to 328 feet (100 m) in length. To ensure proper data transmission, use a Category 6 STP cable or better.
  1. Turn off the projector and HDBaseT transmitter.

     Note: Make sure the projector and HDBaseT transmitter are turned off when connecting or disconnecting a network cable between the two devices.

  2. Connect one end of the network cable to the HDBaseT port on the transmitter.
  3. Connect the other end to the projector's HDBaseT port.
     
     

     Note: See the documentation that came with the HDBaseT transmitter for instructions on connecting it to your video device or computer.

  4. Turn on the projector and HDBaseT transmitter.

  Note: To enable communication from the Ethernet and serial ports on the transmitter, select On as the Control Communications setting in the projector's Extended menu. Turning on this setting disables the projector's LAN, RS-232C, and Remote ports. If you connected an Extron XTP transmitter or switcher to the projector's HDBaseT port, select On as the Extron XTP setting in the projector's Extended menu.

  Connecting to an External Computer Monitor

  If you connected a computer to the projector's Computer or BNC port, or a video source to the projector's 3G/HD/SD SDI port, you can also connect an external monitor to the projector. This lets you see your presentation on the external monitor even when the projected image is not visible.

  If you want to output images to an external monitor when the projector is turned off, you need to select Communication On as the Standby Mode setting and Always On as the A/V Output setting in the projector's Extended menu.

  Note: Monitors that use a refresh rate less than 60 Hz may not be able to display images correctly.

  1. Make sure your computer or video source is connected to the projector's Computer, BNC, or 3G/HD/SD SDI port.
  2. Connect the external monitor's cable to your projector's Monitor Out (for computer or BNC sources) or Monitor Out SDI (for SDI sources) port.

     Note: If you do not see an image on the external monitor when projecting from a computer or BNC source, you may need to change the Monitor Out setting in the Extended menu.

  Related references
  Projector Setup Settings - Extended Menu