There is no sound. What should I do?
- Adjust the projector's volume settings.
- Press the A/V Mute button on the remote control to resume video and audio if they were temporarily stopped.
- Check your computer or video source to make sure the volume is turned up and the audio output is set for the correct source.
- If you do not hear sound from an HDMI source, set the connected device to PCM output.
- If you are using the USB Display function, turn on the Output audio from the projector setting in the Epson USB Display Settings program on your computer.
- If you are using a Mac and you do not hear sound from an HDMI source, make sure your Mac supports audio through the HDMI port. If not, you need to connect an audio cable.
- If you want to use a connected audio source when the projector is off, set the Standby Mode option to Communication On.
- Make sure the A/V Settings options are set up correctly in the Extended menu.
- If you hear a hissing sound from your projector's speakers when projecting from a computer running Windows 10 over a network, you may need to adjust the Windows 10 sound properties:
- Right-click the speaker icon in the Windows taskbar and select Sounds.
- Click the Playback tab, select the playback device, and click Properties.
- Click the Advanced tab, set the sample rate and bit depth setting to 16 bit, 44100 Hz (CD Quality), click Apply, and click OK.
Note: These steps may vary depending on the Windows 10 version you are using.
- If you turn the projector on immediately after turning it off, the cooling fans may run at high speed momentarily and cause an unexpected noise. This is normal.
If there is no sound when you expect it or the volume is too low or high, try the following solutions:
Controlling the Volume with the Volume Buttons
Shutting Off the Picture and Sound Temporarily
Projector Setup Settings - Extended Menu
Projector Setup Settings - ECO Menu
Published: Sep 19, 2019 Was this helpful? Thank you for the feedback!