Support Projectors PowerLite Series Epson PowerLite W70

When and how should I clean or replace the air filter?

  • See below.

    Cleaning the Air Filter and Vents

    Clean the projector's air filter and vents if they get dusty, or if you see a message telling you to clean them.
    1. Turn off the projector and unplug the power cord.
    2. Gently remove the dust using a small vacuum designed for computers or a very soft brush (such as a paintbrush).

      Note: You can remove the air filter to clean both sides. Do not use water or any other solvent to clean the air filter.

      Caution:
      Do not use canned air. The gases may leave a flammable residue or push dust and debris into the projector's optics or other sensitive areas.

    Related tasks
    Turning Off the Projector

    Replacing the Air Filter

    You need to replace the air filter in the following situations:
    • After cleaning the air filter, you see a message telling you to clean or replace it
    • The air filter is torn or damaged

    You can replace the air filter while the projector is mounted to the ceiling or placed upside-down on a table.

    1. Turn off the projector and unplug the power cord.
    2. Place the projector upside-down on a table.
    3. Remove the air filter cover.

    4. Pull the air filter out of the projector.

      Note: Air filters contain ABS resin and polyurethane foam. Dispose of used air filters according to local regulations.

    5. Place the new air filter in the projector as shown and push gently until it clicks into place.

    6. Replace the air filter cover.
    Related references
    Optional Equipment and Replacement Parts
Published:  Jul 2, 2020 Was this helpful?​ Thank you for the feedback!
Was this helpful?​
Please tell us why this was not helpful.​