When and how should I clean or replace the air filter?
-
See below.
Cleaning the Air Filter
You need to clean the projector's air filter in the following situations:- The filter or vents get dusty.
- You see a message telling you to clean it.
- The projector's Filter light flashes orange.
Note: It is recommended that you clean the air filter every 20,000 hours. Clean it more often if the projector is in a dusty environment.
- Carefully remove the dust from the air filter cover with a vacuum or brush.
- Loosen the screws and remove the air filter cover as shown (it is attached with a tether).
- Pull the air filter out of the projector.
- Tap each side of the air filter 4 to 5 times to shake off any excess dust.
Caution:
Do not use excessive force when tapping the air filter, or it may crack and become unusable. Do not rinse the air filter in water, or use any detergent or solvent to clean it. Do not use canned air; the gases may leave a residue, or push dust and debris into the projector's optics or other sensitive areas. - Vacuum the front of the air filter (the side with the tabs) to remove any remaining dust.
Note: If dust is difficult to remove or the air filter is damaged, replace the air filter.
- Vacuum the air intake vent to remove any remaining dust.
- Place the air filter back in the projector as shown.
Replacing the Air Filter
You need to replace the air filter in the following situations:- After cleaning the air filter, you see a message telling you to clean or replace it
- The air filter is torn or damaged
You can replace the air filter while the projector is placed on a table.
- Turn off the projector and unplug the power cord.
- Loosen the screws and remove the air filter cover as shown (it is attached with a tether).
- Pull the air filter out of the projector.
- Place the new air filter in the projector as shown.
- Replace the air filter cover and tighten the screws as shown.
Published: May 23, 2024
Was this helpful? Thank you for the feedback!
