How do I connect my WPS-enabled wireless router to my product?

  • See below.

    Using WPS to Connect to a Network

    If you have a WPS-enabled wireless router or access point, you can use Wi-Fi Protected Setup (WPS) to connect your product to the network.
    1. Press the  home button, if necessary.
    2. Select Wi-Fi. You see a screen like this:

    3. Select Wi-Fi (Recommended).
    4. Select Push Button Setup (WPS).
    5. Follow the instructions on the LCD screen to complete WPS setup.
    6. Press the  home button to exit. You see the icon on the LCD screen and should be able to connect to your product directly from your computer or device, and then print. If you are printing from a computer, make sure you installed the network software as described on the Start Here sheet.

      Note: If you don't see the icon, repeat these steps to try again.

Published:  Nov 22, 2017 Was this helpful?​ Thank you for the feedback!
Was this helpful?​
Please tell us why this was not helpful.​
Please enter a valid email address